138LR  
   Light Duty Belt Driven Live Roller

 
Download Hi-Res Tech Drawings (pdf format)

Download catalog page in pdf format

 
SPECIFICATIONS
TREAD ROLLERS:  1-3/8" dia. x 18 ga. galvanized steel, model 138G with 5/16" hex.

PRESSURE ROLLERS:  1-3/8" dia. x 18 ga. galvanized steel, model 138G with 5/16" hex.

RETURN ROLLERS:  1-3/8" dia. x 18 ga. galvanized steel, model 138G with 5/16" hex, adjustable. 

BELTING:  6" wide black PVC-120 COS.

CENTER DRIVE:  Reversible drive w/ 24" integral belt take-up. Specify location.

DRIVE PULLEY:  4" dia. with 1-3/16" dia. shaft or 8" dia. with 1-7/16" dia. shaft; both crowned and fully lagged.

END PULLEY:  4" dia., crowned, with 1-3/16" dia. shaft.

SPEED:  60 FPM, constant.

MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.

BED: 6" x 1-1/2" x 12 ga. channel frame slotted for tread rollers to pop-out. When unit is installed at 7'-0" elevation or higher, rollers must be retained in conveyor frame. Specify desired elevation. Bed sections attached with couplings and floor supports.

SQUARING RODS: Adjustable rods on underside of bed allow frame to be squared for improved belt tracking and are standard on all units over 30'.

BEARINGS: All pulley bearings are precision, heavy duty, lubricated, ball bearing units with cast iron housings.

FLOOR SUPPORTS: SM-6 adjustable 30-1/2" to 42-1/2" TOR. Supports should be lagged to floor.

ROLLER CHAIN: Drive pulley is driven by No. 50 chain for 1-1/2 HP or less and No. 60 chain on larger drives. Chain take-up provided on motor base.

ELECTRICAL CONTROLS: Optional
3 WEEK SHIPMENT  

Pop-out rollers should be retained in frame if unit is elevated to 7'-0" and above.