196CALR 
  Medium Duty Cam Adjusted Live Roller

 
Download Hi-Res Tech Drawings (pdf format)

Download catalog page in pdf format

 
SPECIFICATIONS
TREAD ROLLERS:  1.9" dia. x 16 ga. steel rollers, model 196S.

PRESSURE ROLLERS:  1.9" dia. x 16 ga. steel, model 196S, cam adjustable.

BELTING:  6" wide black PVC-120 COS.

CENTER DRIVE:  Reversible drive with 24" integral belt take-up. For units under 8'-0" overall length, drive components must be stacked. Consult factory for minimum unit elevation.

SQUARING RODS:  Adjustable rods on underside of bed allow frame to be squared for improved belt tracking and are standard on all units over 30'.

DRIVE PULLEY:  4" dia. with 1-3/16" dia. shaft or 8" dia. with 1-7/16" dia. shaft, both crowned and fully lagged.

END PULLEY:  4" dia., crowned, with 1-3/16" dia. shaft.

RETURN ROLLERS: 1.9" dia. x 16 ga. steel, model 196S, adjustable.

BED: 7" x 1-1/2" x 12 ga. channel frame slotted for tread rollers to pop-out. When unit is installed at 7'-0" elevation or higher, rollers must be retained in conveyor frame. Specify desired elevation. Bed sections attached with couplings and floor supports.

BEARINGS: All pulley bearings are precision, heavy duty, lubricated, ball bearing units with cast iron housings.

FLOOR SUPPORTS: SM-6 adjustable 31-1/2" to 43-1/2" TOR. Supports should be lagged to floor.

MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.

ROLLER CHAIN: Drive pulley is driven by No. 50 roller chain for 1-1/2 HP or less and No. 60 chain on larger drives. Chain take-up provided on motor base.

SPEED: 60 FPM, constant.

ELECTRICAL CONTROLS: Optional
24 Hour Shipments 
Include All 1-Foot Increments
 6'- 0" TO 100'- 0" 		Pop-out rollers should be retained in frame if unit is elevated to 7'-0" and above.