700rr
  Series 400 Raised Rib Plastic Belt Conveyor

 
Download Hi-Res Tech Drawings (pdf format)

Download catalog page in pdf format
 
SPECIFICATIONS
BELTING: Series 400 raised rib gray polypropylene belt, FDA approved belt. Finger transfer plates provided both ends of conveyor to facilitate smooth product transfer.

DRIVE SPROCKETS: 7.8" pitch dia. with 1.5" square bore. Available with OPTIONAL 10.1" pitch dia. sprockets with 1.5" or 2.5" square bore.

TAIL SPROCKETS: 7.8" pitch dia. with 1.5" square bore. Available with OPTIONAL 10.1" pitch dia. sprockets with 1.5" or 2.5" square bore.

BED: 7" x 1-1/2" x 10 ga. channel frame with open style bed construction and UHMW wearstrips mounted to longitudinal channels.

END DRIVE: Allows one-direction (unit) operation.

BELT SPEED: 60 FPM, constant.

BEARINGS: Drive and tail shaft bearings are precision, heavy duty, lubricated, ball bearing units with cast iron housings.

TAKE-UP: Catenary type located at discharge end.

RETURN ROLLERS: 1.9" dia. x 16 ga. steel, model 196S, adjustable with rubber sleeves.

FLOOR SUPPORTS: SM-6 supports provided at both ends and each bed joint and should be lagged to floor.

MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.

ROLLER CHAIN: Drive shaft is driven by No. 50 roller chain for 1-1/2 HP or less and No. 60 chain on larger drives. Chain take-up provided on motor base.

ELECTRICAL CONTROLS: Optional.
3  WEEK SHIPMENT To prevent pinch points that exist when belt conveyors are permanently attached to other conveyors, use connector brackets with safety pop out roller (other stationary equipment will require proper guarding and safety devices supplied by others).