700rt

SPECIFICATIONS

BELTING: Series 400 roller top gray polypropylene belt, FDA approved belt.

DRIVE SPROCKETS: 7.8" pitch dia. with 1.5" square bore. Available with OPTIONAL 10.1" pitch dia. sprockets with 1.5" or 2.5" square bore.

TAIL SPROCKETS: 7.8" pitch dia. with 1.5" square bore. Available with OPTIONAL 10.1" pitch dia. sprockets with 1.5" or 2.5" square bore.

END DRIVE: Allows one-direction (unit) operation.

TAKE-UP: Catenary type located at discharge end.

RETURN ROLLERS: 1.9" dia. x 16 ga. steel, model 196S, adjustable with rubber sleeves.

BELT SPEED: 60 FPM, constant.

BEARINGS: Drive shaft bearings are precision, heavy duty, lubricated, ball bearing units with cast iron housings.

BED: 7" x 1-1/2" x 10 ga. channel frame with open style bed construction and UHMW wearstrips mounted to longitudinal channels.

FLOOR SUPPORTS: SM-6 supports provided at both ends and each bed joint and should be lagged to floor.

MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.

ROLLER CHAIN: Drive shaft is driven by No. 50 roller chain for 1-1/2 HP or less and No. 60 chain on larger drives. Chain take-up provided on motor base.

ELECTRICAL CONTROLS: Optional.

3 WEEK SHIPMENT

To prevent pinch points that exist when belt conveyors are permanently attached to other conveyors, use connector brackets with safety pop out roller (other stationary equipment will require proper guarding and safety devices supplied by others).