Line Shaft Diverging Switch Module


Download Hi-Res Tech Drawings (pdf format)

Download catalog page in pdf format

TREAD ROLLERS: 1.9" dia. x 16 ga. steel, model 196S grooved, 3" centers.

DRIVE BELT: 3/16" dia., polyurethane belts. Nominal 15 lbs. per roller drive.

DRIVE SHAFT: 1" dia. C1018 cold rolled steel shaft. NOTE: Spools in spur section only are keyed to provide positive drive (designed not to slip on drive shaft).

COUPLINGS: Couplings located both ends or one end only. Specify where couplings required.

BED: 7" x 1-1/2" x 12 ga. formed steel channel frame. Short side of spur is always 12" overall length.

BEARINGS: Precision, lubricated, ball bearing units with composite housings.

FLOOR SUPPORTS: SM-6 adjustable 31-1/2" to 43-1/2" TOR. Supports should be lagged to floor.

MOTOR DRIVE: Unit is designed to be driven by 796LS.

ROLLER CHAIN: Spur driven via crossover with No. 40 chain.

4 WEEK SHIPMENT NOTE: This unit is not designed for high-rate 
sortation. Consult Con Inc. for high-rate applications.