796lsZ 
  Line Shaft Zero Pressure Accumulator

 
Download Hi-Res Tech Drawings (pdf format)

 
SPECIFICATIONS
TREAD ROLLERS:  1.9" dia. x 16 ga. steel, model 196S grooved.

DRIVE BELT:  3/16" dia., polyurethane belts. Nominal 15 lbs. per roller drive.

DRIVE SHAFT:  1" dia. C1018 cold rolled steel shaft.

COUPLINGS:  Couplings located both ends (type "A"), one end only (type "B" or "C") or none (type "D"). See 'line shaft coupling chart' opposite page, and specify.

CENTER DRIVE:  Located approximately 16-1/2" from end of bed section on 4" RC; 18" on 3" and 6" RC.

ACCUMULATION: 2'-0" zonelength; pneumatically actuated, zone singulation operation.

FRL:  Unit is provided with filter, regulator, lubricator with 1/4" ports.

SPEED:  60 FPM, constant.

BEARINGS:  All bearings are precision, lubricated, ball bearing units with composite housings.

BED:  7" x 1-1/2" x 12 ga. formed steel channel frame. Bed sections attached with splice plates and floor supports.

FLOOR SUPPORTS:  Optional

MOTOR DRIVE:  1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.

ROLLER CHAIN:  Drive shaft is driven by No. 50 chain. Chain take-up provided on motor base.

CAPACITY:  See page 5 in technical section for load capacity rating.

ELECTRICAL CONTROLS:  Optional
3 WEEK SHIPMENT  
E-mail:  sales@conveyors-inc.com

Phone: (205) 620-4116
CONVEYOR SYSTEMS, STORAGE SYSTEMS AND COMPONENTS
1975 - OVER THIRTY YEARS OF SERVICE - 2006