pc-f  
  Parts Conveyor With Feeder

 
Download Hi-Res Tech Drawings (pdf format)

Download catalog page in pdf format

 
SPECIFICATIONS
BELTING: 3-ply black nitrile belt or 1/2" x 1" flat wire mesh belt with 1-1/2" high galvanized cleats on 12" centers.

DRIVE PULLEY: 4" dia., with 1-3/16" dia. shaft, fully lagged with nitrile belt; 4" dia. sprockets supplied with flat wire mesh belt.

TAIL PULLEY: 4" dia. with 1-3/16" dia. shaft.

TAKE-UP: Screw type unit at tail pulley provides 12" belt take-up.

BED: 8" deep x 12 ga. enclosed box type construction with 14 ga. steel belt return pan.

BEARINGS: All pulley bearings are precision, heavy duty, lubricated, ball bearing units with cast iron housings.

BELT SPEED: 35 FPM, constant.

MINIMUM PARTS SIZE: 1/2" cube for nitrile belt, 1" cube for flat wire mesh belt.

INCLINE: 30, 36 and 45° (specify). 

PORTABLE SUPPORT: Adjustable floor support with 4" dia. casters and bracing.

MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.

CAPACITY: 350 lbs. total distributed load.

ROLLER CHAIN: No. 50 chain provided at drive pulley. Chain take-up provided on motor base.

ELECTRICAL CONTROLS: Optional.
3  WEEK SHIPMENT NOTE:  "A" or "B" dimensions not to exceed 10'. Combined lengths of "A" and "B" not to exceed 15'. Cleat centers must not exceed 12". Cleats available in rigid construction ONLY. Consult factory for optional cleats.
Minimum parts size of 1/2" cube for neoprene belt, 1" cube for flat wire mesh belt.