Medium Duty Zero Pressure Live Roller Accumulator


Download Hi-Res Tech Drawings (pdf format)

Download catalog page in pdf format

TREAD ROLLERS:  1.9" dia. x 16 ga. steel, model 196S.

PRESSURE ROLLERS:  1.9" dia. x 16 ga. steel, model 196S; 8" BF with 6" wide belt.

BELTING:  6" wide black PVC-120 COS.

DRIVE PULLEY:  4" dia. with 1-3/16" dia. shaft or 8" dia. with 1-7/16" dia. shaft, both crowned and fully lagged.

END PULLEY:  4" dia., crowned, with 1-3/16" dia. shaft.

RETURN ROLLERS:  1.9" dia. x 16 ga. steel, model 196S, adjustable.

SQUARING RODS:  Adjustable rods on underside of bed allow frame to be squared for improved belt tracking and are standard on all units over 30'.

BED:  7" x 1-1/2" x 12 ga. channel frame slotted for tread rollers to pop-out. When unit is installed at 7'-0" elevation or higher, rollers must be retained in conveyor frame. Specify desired elevation. Bed sections attached with couplings and floor supports.

  60 FPM, constant.

BEARINGS:  All pulley bearings are precision, heavy duty, lubricated, ball bearing units with cast iron housings.

ACCUMULATION: 2'-0" long zones pneumatically actuated. 1'-0" of live roller over end plates at each end of conveyor remains "live" during operation (# of zones x zone length + 2' = overall conveyor length).

PNEUMATIC ACTUATION:  Maximum air line pressure should not exceed 30 PSI.

FRL: Unit is provided with filter, regulator, lubricator with 1/4" ports. 

FLOOR SUPPORTS:  SM-6 adjustable 31-1/2" to 43-1/2" TOR. Supports should be lagged to floor.

MOTOR DRIVE:  1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.

ROLLER CHAIN:  Drive pulley is driven by No. 50 roller chain for 1-1/2 HP or less and No. 60 chain on larger drives. Chain take-up provided on motor base.


3 WEEK SHIPMENT Pop-out rollers should be retained in frame if unit is elevated to 7'-0" and above.