700pbc 
  Series 2200 Flush Grid Plastic Belt Curve

 
Download Hi-Res Tech Drawings (pdf format)

Download catalog page in pdf format

 
SPECIFICATIONS
BELT: Series 2200 flush grid gray curved polypropylene belt, FDA & USDA approved belting.

DRIVE SPROCKETS: 5.3" pitch dia. with 1.5" square bore. Available with OPTIONAL 6.3" or 7.7" pitch dia. sprockets with 1.5" or 2.5" square bore.

TAIL SPROCKETS: 5.3" pitch dia. with 1.5" square bore. Available with OPTIONAL 6.3" or 7.7" pitch dia. sprockets with 1.5" or 2.5" square bore.

END DRIVE: Allows one-direction operation ONLY; this conveyor is NOT reversible.

TAKE-UP: Catenary type located at discharge end.

BED: 7" x 1-1/2" x 10 ga. formed steel channel frame with UHWW wearstrips attached to bed and belt return pan. 

MINIMUM RADIUS: 2.2 x belt width, measured from inside edge of belt.

SPEED: 60 FPM, constant.

TANGENTS: Minimum length is 1.5 x belt width located at each end of conveyor; minimum of 3' at discharge end required with 5' recommended.  Optional additional tangent may be located at dischg. end.

FLOOR SUPPORTS: SM-6 supports provided at both ends and at center of curve and should be lagged to floor.

BEARINGS: End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings.

DIRECTION OF FLOW: Specify right hand or left hand.

MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor on 45° and 90° curves; 3/4 HP supplied on all 180° curves.

ROLLER CHAIN: Drive shaft is driven by No. 50 chain.

ELECTRICAL CONTROLS: Optional.
3  WEEK SHIPMENT To prevent pinch points that exist when belt conveyors are permanently attached to other conveyors, use connector brackets with safety pop out roller (other stationary equipment will require proper guarding and safety devices supplied by others).